Good little glue gun to be used with 7mm sticks. At 12V it pulls about 0.7A. So it's actually less than 10W and not 30W as said in the description. I also noticed that the glue hardens too quickly because it doesn't get very hot. Good enough for small repairs.

Good little glue gun to be used with 7mm sticks. At 12V it pulls about 0.7A. So it's actually less than 10W and not 30W as said in the description. I also noticed that the glue hardens too quickly because it doesn't get very hot. Good enough for small repairs.

Good little glue gun to be used with 7mm sticks. At 12V it pulls about 0.7A. So it's actually less than 10W and not 30W as said in the description. I also noticed that the glue hardens too quickly because it doesn't get very hot. Good enough for small repairs.

I'm super impressed with this little glue gun, it takes 7.1mm glue sticks which are dead cheap. Also unlike the description says you CAN run this with a 2S battery and the glue did get hot enough to be usable. Because the nozzle is so small you can make some super accurate gluing with it. The only negatives I can think of id that the lead is too short and it's plastic coated wire rather than silicone coated. So 8/10 for it and the ON position is when the switch is down, identified by the little circle on the switch. Hope that helps!

I'm super impressed with this little glue gun, it takes 7.1mm glue sticks which are dead cheap. Also unlike the description says you CAN run this with a 2S battery and the glue did get hot enough to be usable. Because the nozzle is so small you can make some super accurate gluing with it. The only negatives I can think of id that the lead is too short and it's plastic coated wire rather than silicone coated. So 8/10 for it and the ON position is when the switch is down, identified by the little circle on the switch. Hope that helps!

I'm super impressed with this little glue gun, it takes 7.1mm glue sticks which are dead cheap. Also unlike the description says you CAN run this with a 2S battery and the glue did get hot enough to be usable. Because the nozzle is so small you can make some super accurate gluing with it. The only negatives I can think of id that the lead is too short and it's plastic coated wire rather than silicone coated. So 8/10 for it and the ON position is when the switch is down, identified by the little circle on the switch. Hope that helps!