vyper1
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

vyper1 30/01/2019
I wouldn't say they are super loud but I can hear them clearly and that is all that's required.
5 PCS Super Loud 5V Active Alarm Buzzer Beeper Tracker 9*5.5mm for RC MultiRotor FPV Racing Drone
US$6.99 US$8.99
0
Recommendations
Comments (0)
vyper1 30/01/2019
Decent enough lipo checker to use at the field and at home for that quick status check. On occasion it's reading up to minus .03 V below the reading my charger or a multimeter gives but this is perfectly acceptable. Only thing I think this is missing, is a back light for low-light situations as the screen isn't the most visible.
3 In 1 2S-6S Discharger Voltage Tester Balancer for Li-Po Li-Fe Battery
US$12.50 US$19.19
1
Recommendations
Comments (0)
vyper1 30/01/2019
Good pins with a nice small 90 degree bend
10Pcs Lantian 2.54mm Gold-plated 3U Reverse Curved Single Row Pin Header Connector
US$1.66 US$3.10
0
Recommendations
Comments (0)
vyper1 30/01/2019
This is my 1st quad so I have nothing to benchmark it against. I've done a few flights with it now and for me I think it's a fantastic quad. All I can say with 100% certainty are the things I don't like about this kit. I made the mistake of going to cut the motor wires to the exact length only to find out that it is the worst wire I have come across. Luckily I had only cut one of the wires before I realised not to cut them. There is absolutely minimal room within the frame to mount anything other than a micro RX and when you do fit this then make sure it's well isolated from the frame as it will induce unwanted vibration to the FC. I have installed anti vibration mounts for the FC as well as soft mounts for the motors just to make sure I don't get any erratic gyro behaviour. Even though this is my first quad I did find the camera to be a bad performer especially in low-light and transitioning from light to dark, so I swapped it out for a Foxeer Monster V3. I have managed to squeeze in a buzzer just behind the stack and I have replaced the antenna for a stubby one which is performing just as well as the long one that came with the kit. I have also managed to fit Leds around the quad which helps greatly when I fly LOS, so I would now say this kit is complete. Like I said, this is my 1st quad so I have nothing to compare its performance against but for me I find it a great first timer and it should help me learn at a reasonable cost.
Eachine Tyro99 210mm DIY Version FPV Racing RC Drone F4 OSD 30A BLHeli_S 48CH 200mW VTX 700TVL Camera
US$135.00 US$160.99
0
Recommendations
Comments (1)
vyper1 30/01/2019
Good little battery indicator and the fact you can set it for multiple voltages is a real bonus. So I have ordered a couple more for some more projects I'm doing. No instructions but you can figure out how it goes together, I'd suggest you install the bar display before you do the IC otherwise you can't have it flush.
LM3914 Battery Capacity Indicator Module LED Power Level Tester Display Board
US$4.99 US$8.54
0
Recommendations
Comments (1)
vyper1 30/01/2019
Simple motor controller, works perfectly well.
Mini DC 4.5V To DC 35V 5A 90W DC Motor PWM Speed Controller Module Speed Regulator Adjustable Switch Board
US$2.42 US$3.59
0
Recommendations
Comments (0)
vyper1 29/12/2018
seems to be decent enough quality and will come in handy.
Professional Angle Template Tool Angle Measuring Tool Protractor Multi-Angle Ruler Layout Tool Ruler
US$4.88 US$19.61
0
Recommendations
Comments (0)
vyper1 25/12/2018
Markings are off at the start of the ruler but other than that, they are fine.
1pcs 15cm Double Side Stainless Steel Measuring Straight Ruler Metric Silver
US$4.75 US$9.99
0
Recommendations
Comments (1)
vyper1 25/12/2018
Used these to bind RX from TX module pins
Test Clamp Wire Hook Test Clip for Logic Analyzer
US$6.29 US$8.99
0
Recommendations
Comments (0)
vyper1 19/12/2018
Not used it yet but I can't see there being any problems. Seems to be a decent amount of windings so should last a while.
0.5mm 63/37 Tin lead Solder Wire Rosin Core Soldering 2% Flux Reel Tube
US$2.88 US$3.15
0
Recommendations
Comments (0)
vyper1 19/12/2018
Slight issue with the fact that the ruler doesn't start at 0. The 1st mark is about 1.5mm in size. Once you take that into consideration then you'll make no mistakes. They come in individual sleeves which is a bonus.
1pcs 15cm Double Side Stainless Steel Measuring Straight Ruler Metric Silver
US$4.75 US$9.99
0
Recommendations
Comments (1)
vyper1 18/12/2018
Not put them to test yet but all cells balanced and they seem to be in good order. Hopefully they work as expected.
ZOP Power 11.1V 1500mAh 40C 3S Lipo Battery XT60 Plug for Eachine Wizard X220 FPV Racing RC Drone
US$19.99 US$26.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
I've built 5 of these and all have worked perfectly. My only gripe is they switched the power button and I'd prefer if these were micro usb powered instead of the barrel.
Geekcreit® DIY Christmas Tree LED Flash Kit 3D Electronic Learning Kit
US$7.99 US$13.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
Only time will tell to see how long they last.
DANIU Electrical Cutting Plier Wire Cable Cutter Side Snips Flush Pliers Tool
US$5.19 US$12.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
but does not work, red leds remain very dull and the aren't much better. There is no flashing so i think there's an issue with the IC
Geekcreit® DIY Star Effect 3D LED Decorative Christmas Tree Kit
US$5.99 US$7.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
USB boards, perfect for my build.
5pcs Micro USB To Dip Female Socket B Type Microphone 5P Patch To Dip 2.54mm Pin With Soldering Adapter Board
US$6.99 US$7.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
It cleans your tip.
1PC Heavy Duty Soldering Solder Iron Tip Cleaner Steel Wire Soldering Supplies
US$8.99 US$14.99
0
Recommendations
Comments (0)
vyper1 18/12/2018
It solders things together.
50g 0.5/0.6/0.8/1.0mm 63/37 FLUX 2.0% 45FT Tin Lead Tin Wire Melt Rosin Core Solder Soldering Wire Roll
US$4.66 US$10.99
0
Recommendations
Comments (0)
vyper1 17/12/2018
Used mainly for sticking down Frsky RX to quadcopter and it does the trick.
10M Double Sided Adhesive Tape Super Sticky Acrylic Foam Sticker for Car Auto Interior Fixed
US$3.76 US$5.99
0
Recommendations
Comments (0)
vyper1 16/12/2018
To start with, I have large hands but this form factor suits me ok and I don't have any issues with its smaller size. The buttons for open tx menu navigation are a bit unintuitive but after a while you get used to it. The gimbals seem fine and precise enough and the only thing this transmitter is missing is a momentary switch but overall it is a good TX and worth the money. My only true gripe is the bind process for some of the protocols you only get 2 or 3 bind chirps and dependent on the RX you are binding too,especially if it's one you have to start bind on TX then hold button on RX as applying power to it, then sometimes 2 or 3 bind chirps is not enough time. If this can be increased then please let me know. I'm also struggling to find a 2S lipo that will fit the battery compartment as this TX will eat through AA and NiMH in no time. But, overall I'm pleased with this Jumper T12 and only time will tell to see if it will stand the test of time.
Jumper T12 OpenTX 16CH Radio Transmitter with JP4-in-1 Multi-protocol RF Module for Frsky JR Flysky
US$91.79 US$105.61
0
Recommendations
Comments (0)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe